|
|
|
| HOME | Install Guide | User Guide | Videos | Software Updates | Troubleshoot | FAQ | ONELAN |
|
|
Reboot the NTB if not already done. |
Just pull the power cable out and put it back in again after 2 seconds. |
|
|
A green "OK" for "eth0" should appear on the Display Device during NTB boot-up. |
A red "eth0 [Fail]" usually means that the NTB found nothing to connect with at the other end of the cable. |
|
|
The IP address should appear on the display screen during the NTB boot sequence. |
A "No Cable" message means that the cable is missing or faulty or that there is another device on the network with the same IP address. |
|
|
The NTB must have completed it's boot sequence. |
The Display Device connected to the NTB should be showing the default Layout and content. |
|
|
The yellow LEDs on all applicable network sockets should be on or flashing. |
Check the yellow light (if present) on the socket that the network cable plugs into on your PC, on the NTB and any hubs or routers in the path from the PC to the NTB (if applicable). |
All the above boxes could be ticked.
I could not tick all of the above boxes.
